Wasp Bar Code WPA1200 - Manual (Page 2)

Front Left View
1. Status Indicator
2. Left scan trigger button
3. Power
button
4. Microphone
5. Universal
connector
6. Keypad
7. LCD touch screen
8. Speakers
Back View
9. Battery compartment
10. Battery compartment release Latch
11. Reset button
12. Handstrap
13. Speaker
14. Strap holder
15. Memory card slot
16. Barcode scanner window
17. Earphone Jack
18. Stylus
19. Right scanner trigger button
20. Infrared (IR) Port
1. Turning the WPA1200 On for the
First Time
After you have initially charged your
device for about 12 hours, the device is
ready to be used. You can now start up
your device where you’ll calibrate the
display, learn some basic stylus usage,
and set up the system time zone, date and
time.
2. Powering On
Turn on your device by pressing the power
button on the front panel. (Number 3 in the
graphic above.)
3. Installing the Battery Pack
Open the battery compartment by pushing
the latch in the direction of the arrow and
lifting up.
Position the battery pack, making sure the
battery contacts are aligned with the
contacts in the compartment and the
battery is placed on top of the plastic tab,
as shown in the following illustration.
Slide the battery pack into the battery bay
while simultaneously pulling the plastic tab
and securing clip until the battery clicks
into place.
Replace the battery compartment cover.
4. Charging the Battery
a. Press and hold the connector
button on the USB charging
cable and connect it to the
WPA1200.
b. Plug the AC adapter cable into
the power jack on the USB
charging cable (2).
c. Connect the AC adapter into
an electrical outlet (3).
Plastic Battery
Tab
Compartment
Contacts
Battery Securing
Clip
Clip
Tab