Care and cleaning, Removing the handles and doors – White-Westinghouse 218954301 User Manual

Page 13

Advertising
background image

13

Vacation and Moving Tips

Short vacations:
• Leave the refrigerator operating during vacations of 3 weeks or less.
• Use up all perishable items from the refrigerator section.
• Wrap and store other items in the freezer.
• Turn off the automatic ice maker, even if you will be gone just a few days.

Care and Cleaning

(continued)

Long vacations:
• Remove all food and ice if you will be gone 1 month or more.
• Turn controls to OFF and disconnect power.
• Turn off automatic ice maker and turn water supply valve to the closed

position.

• Clean interior thoroughly. Leave both doors open to prevent odor and mold

build-up. Block open if necessary.

Moving: When moving refrigerator, follow these guidelines to prevent damage:
• Remove all food and other items from both the refrigerator and freezer

compartments.

• Empty ice storage bin.
• If a hand truck is used in moving, load refrigerator from the side.
• Turn rollers as far up as possible. This will protect them during sliding or moving.
• Cabinet should be well padded and handled with care. DO NOT DROP.

IMPORTANT
If the refrigerator is going to be stored or moved in freezing temperatures, the
water in the ice and water system must be drained completely. Failure to do so
could result in water leaks when the refrigerator is put back in service.
Contact a service representative to perform this operation.

Removing the Handles
and Doors

If it is necessary to move the refrigerator through narrow doorways, follow
these steps to remove the handles and/or refrigerator and freezer doors.

To Remove Handles

Full-length Trim:
1. Using a putty knife, carefully slide the corner of the blade under the trim. Slide

blade down until you find the trim lock. Carefully maneuver the blade against the
trim lock from the side as shown. NOTE: Pressing down on the trim lock from
above will not release it.

2. Carefully push the putty knife firmly against the trim lock and twist gently. The

trim lock will snap free from the door. (Each trim piece will have two trim locks.)

3. Grasp trim and pull up away from handle using a slight side-to-side motion.
4. Remove screws attaching handle to door.
5. Repeat these steps for each handle end. Keep screws and trim pieces.
6. To replace handles, line up handle with screw holes, insert screws and tighten.

Slide upper and lower trim pieces back on handle ends, and snap trim locks back
into holes on door front.

To Remove Doors

Before removing the doors, be sure the freezer control is turned to OFF. Remove all
food from the doors and unplug the refrigerator. Remove the toe grill.

Trace around the hinges with a soft lead pencil. This will make it easier to realign
the doors when they are replaced. Completely remove one door before starting
removal of the other.

C05I0122

Removing handles and trim

Advertising