Whirlpool YMH7140XF - Manual (Page 7)

7
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
R
EMOVING AND REPLACING THE MICROWAVE OVEN
If you need to remove your Microwave Hood Combi-
nation for any reason, follow these simple steps:
To remove:
1. Unplug microwave oven or disconnect power.
2. Remove filters and vent grille.
• If filters are
installed, push in at the
tab and slide filter to the
outside edge to remove.
• Remove the two
screws from the top
of the microwave oven
cabinet (the screws
located closest to the
front corners). Do not
remove the screws
located towards the center of the cabinet.
• Remove the vent grille . Set the screws and
grille aside.
3. After removing all oven contents, including the
turntable and support,
tape the door in the
closed position. Then
remove the two bolts
securing the
microwave oven to the
upper cabinet.
w WARNING
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or
other injury.
B
C
A
D
E
F
G
4. While wearing gloves, grasp the microwave oven
supports and firmly
pull the microwave oven
forward and downward to
release the microwave
oven cabinet from the
mounting plate locking
pins
.
5. Grasp the microwave oven cabinet. Rotate the
microwave oven down-
ward. (Be careful that
door does not swing
open.) Lift off the support
tabs
at the bottom of
the mounting plate. Set
the microwave oven
aside on a protected
surface.
continued on next page