Wharfedale PM500 - Manual (Page 4)

WHARFEDALE PROFESSIONAL PM SERIES POWERED MIXERS
INTRODUCTION:
Congratulations on the purchase of your PM System from Wharfedale Professional. The PM System is
available in a choice of two versions - the PM 500 and the PM 600. The PM500 System comprises 1 x
PM 500 powered mixer, two PT10 two way 10” loudspeakers and one DM1.0 dynamic microphone (plus
one mic cable and two speaker cables).The PM600 System comprises 1 x PM600 powered mixer, two
PT12 two way 12” loudspeakers and one DM1.0 dynamic microphone (plus one mic cable and two speak-
er cables).
In order to get the most satisfaction from your PM System, please read this manual carefully.
GETTING STARTED:
1. Before you turn on the main power to the unit, ensure that the Master Output Control is in the OFF
position.
2. If you need to connect or disconnect any cables or units, make sure the Power is OFF before doing so.
3. Check that the voltage of the unit matches the AC voltage you will be operating with.
FEATURES OF THE PM POWERED MIXER SECTION OF YOUR SYSTEM:
FEATURES:
PM600
•
Five Mic and six line input sockets
• Channel six features extra Tape In button
• Digital Delay Section
• Three Band EQ in Master Section
• Tape In
• Record Out
• EFX Return
• EFX Send
• Power On/Off on front of unit for ease of use
• Parallel speaker outputs on rear of unit
• Main line output on rear of unit
• Built in 230 watt power amplifier
• Two band channel EQ
• XLR plus 1/4” input sockets
• Fan cooling system
• Thermal protection
PM500
•
Four Mic and five Line input sockets
• Channel five features Tape In Button
• Main line output on rear of unit
• Two band Channel EQ
• XLR plus 1/4” input sockets
• Digital Delay Section
• Record Out
• Built in 120 watt power amplifier
• Thermal protection
PM Series Instruction Manual Page 3