Wells FT-18 - Manual (Page 6)

INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
WARNING:
Risk of
personal injury
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical and
plumbing codes. Failure can
result in personal injury and
property damage.
CAUTION:
ELECTRIC SHOCK
HAZARD
This appliance is
equipped with a grounding
system to protect you from
electrical shock in the event of
internal damage. DO NOT cut
or remove the large ground
prong on the plug. DO NOT
twist any blade on the plug
to fit an existing receptacle.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from the
Appliance before connecting electrical power or otherwise performing
any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
SETUP
Setup the appliance only on a firm, level surface. Verify local codes
for requirements. Concrete, tile, terrazzo or metal surfaces are
recommended.
Install provided 4" adjustable legs, one on each corner of the appliance,
in the holes provided. Verify that the unit sits firmly ON ALL FOUR
LEGS. With a spirit level, check that the appliance is level front-to-back
and side-to-side. With the adjustable legs, adjust as required to level
the appliance. All four legs must be adjusted to firmly contact the
countertop in order to prevent tipping.
Refer to the Installation Instruction Sheet for required clearances.
Maintain required clearances between the appliance and adjacent
combustible surfaces.
Avoid storing flammable or combustible materials in, on or near the
appliance.
ELECTRICAL
This appliance requires a properly grounded 30 amp 208 or 240 VAC
single phase circuit and NEMA 6-30R receptacle.
This appliance conforms to NSF Standard 4 for sanitation only if
installed in accordance with the supplied Installation Instructions and
maintained according to the instructions in this manual.
This appliance is
U
Listed under UL File E6070 for 208V and 240V.
This appliance is
V
Listed under UL File E6070 for 208V and 240V .
STD 4
E6070
E6070
AGENCY LISTING INFORMATION
4