Traction control / auger control lock, Auger drive control, Chute tilt control – White Outdoor Snow Boss 750T User Manual

Page 7: Skid shoe, Chute directional control

Advertising
background image

7

If the machine can be moved freely both forward and
rearward when the traction control fully depressed,
proceed as follows:

Loosen the jam nut on the traction drive cable and
THREAD the cable in one full turn.

Recheck the adjustment and repeat adjustment as
necessary.

Retighten the jam nut to secure the cable when
correct adjustment is reached.

If you are uncertain that you have reached the correct
adjustment, refer to Traction Control Adjustment in
Adjustment Section.

SECTION 3: KNOW YOUR SNOW THROWER

Figure 7

WARNING: Read, understand, and follow
all instructions and warnings on the
machine and in this manual before
operating.

Traction Control / Auger Control Lock

The traction control is located on the right handle.
Squeeze the traction control to engage the wheel drive.
Release to stop. See Figure 7.

This same lever also locks the auger control so you
can turn the chute directional control without
interrupting the snow throwing process. If the auger
control is engaged along with the traction control, the
operator can release the auger control (on the left
handle) and the augers will remain engaged. Release
the traction control to stop both the augers and track
drive (auger control must also be released).

IMPORTANT:

Always release tractional control before

changing speeds.

Auger Drive Control

The auger drive control is located on the left handle.
Squeeze the control grip to engage the augers.

Release to stop the snow throwing action. (Traction
control must also be released.) See Figure 7.

Chute Tilt Control

The distance snow is thrown can be changed by
adjusting the angle of the chute assembly. Move the
chute tilt control forward to decrease the distance,
toward the rear to increase. See Figure 7.

Skid Shoe

The position of the skid shoe is determined by the
condition of the ground from where snow has to be
removed. See Figure 7.

Chute Directional Control

The chute directional control is located on left side of
the snow thrower. See Figure 7.

To change the direction in which snow is thrown, turn
chute directional control as follows:

Crank clockwise to discharge to the left.

Crank counterclockwise to discharge to the right.

Closed

Open

Traction Control /
Auger Control Lock

Shift Lever

Chute Tilt
Control

Auger Drive Control

Skid Shoe

Auger

Headlight

Discharge
Chute

Track Steering
Control

Switch
Box

Electric
Starter
Button

Recoil
Starter
Handle

Primer

Choke

Safety
Ignition Key

Throttle
Control

Chute Directional
Control

Advertising