Western Telematic SRM-100 User Manual
Page 51
Register
Range
Default
Function
S29
0 - 255
---
Flash Dial Modifier Time. Sets the length of time (in hundredths of a
second) that the modem will go off-hook when it encounters the flash (!) dial
modifier in the dial string.
S30
0 - 255
---
Disconnect Inactivity Timer. Sets the length of time (in 10 second intervals)
that the modem will stay on-line before disconnecting when no data is sent or
received. In error-correction mode, any data transmitted or received will
reset the timer. In other modes, any data transmitted will reset the timer.
The timer is inoperative in synchronous mode.
S31
---
---
Bit Mapped Options.
Bit
Option
Val
Description
Cmd
0
Not Used
1
Speed Detection
0
Disabled
N0
1
Enabled
N1
2,3
Progress Messages
0
DTE Speed
W0
1
Full Reporting
W1
2
DCE Speed
W2
4-7
Not Used.
S32
0 - 255
17
XON Character. Stores the ASCII decimal code for the XON character.
S33
0 - 255
19
XOFF Character. Stores the ASCII decimal code for the XOFF character.
S36
0 - 7
7
V.42 Negotiation Failure Treatment. This register is read when the S48
register equals 128 or if an attempted V.42 connection fails. These fallback
options are initiated immediately upon connection if S48 = 128.
S36=0
Modem Disconnects.
S36=1
Modem stays on-line and a direct mode connection is established.
S36=2
Reserved.
S36=3
Modem stays on-line and a normal mode connection is
established.
S36=4
An MNP connection is attempted. If this connection fails, the
modem then disconnects.
S36=5
An MNP connection is attempted. If this connection fails,
a direct mode connection is established.
S36=6
Reserved.
S36=7
An MNP connection is attempted. If this connection fails, a
normal mode connection is established.
S37
0 - 21
0
Desired Connection Rate.
S37=0
Attempt auto mode connection.
S37=1-3
Attempt to connect at 300 bps.
S37=4
Reserved.
S37=5
Attempt to connect at 1200 bps.
S37=6
Attempt to connect at 2400 bps.
S37=7
Attempt to connect at V.23
S37=8
Attempt to connect at 4800 bps.
S37=9
Attempt to connect at 9600 bps.
S37=10
Attempt to connect at 12K bps.
S37=11
Attempt to connect at 14.4K bps.
S37=12
Attempt to connect at 7200 bps.
10-5
SRM-100 - Secure Rack Modem, User's Guide
S-Registers