Windsor SUPREME ULTRA HIGH SPEED BURNISHER P1700120 - Manual (Page 4)

GENERAL
faults
Red will not
come on or out
when trying to start
Red light on
will not start
Poor
trips circuit
or blows
Machine “wobbles”
in
Not plugged not
switched on
Faulty plug connections
fuse blown or wrong
fuse fitted
Faulty supply cable
Wrong supply voltage
Handle not in operating
position
Handle assembly not
plugged into motor
Circuit breaker tripped
motor overloaded
Wrong supply voltage.
Floor pad
centered.
REMEDY
Plug and switch on
Open plug and inspect
connections
cable re-
straint
-
fit a new fuse
Check by substitution
Check name plate.
Lower handle
Plug handle assembly
into motor
Press red button to reset
circuit breaker
-
wash
or replace floor pad.
Check name Plate
Check floor pad for uneven
wear
-
center on the
drive plate.
WINDSOR LIMITED WARRANTY
WINDSOR warrants to the original for a of one
year from date of purchase that this Rotary Floor Machine IS free
from defects in and materials, under normal use and
service. and when operated and maintained in accordance with
Windsor’s service and operating instructions This warranty does
apply to normal wear such as electrical cable relays
capacitors. rubber parts and switches During this one year period
Windsor will replace or repair defective parts covered b this war
when the machine delivered either to the
Colorado or to an Authorized Windsor Service Center
Costs are to be by the original
EXTENDED WARRANTY
addition to the above warranty, the following w i l l apply
1 In the event of failure from normal usage during the useful life
Of the machine of the main switch located in the ma
chine handle switch housing. WINDSOR will replace or repair
such switch free of cost except for labor and transportation
charges which must be borne by the original purchaser
2 For a period of three years after purchase WINDSOR with-
out charge replace or repair any motor that fails as a result of
defects during normal service and usage except for normal
wear items as described above and for transportation charges
to and from the Windsor factory which must be prepaid by the
original purchaser
This warranty is in lieu of all other warranties. expressed or implied.
and releases WINDSOR from all other obligations and liabilities It
is applicable only the U S A and Canada, and extended
to the original user purchaser of this product
WINDSOR is not responsible for costs for repairs performed by
other persons unless they have been specifically authorized in
advance and in writing by WINDSOR This warranty
does not apply
to damage from transportation alterations by unauthorized persons
misuse
or abuse of the equipment use of chemicals
or damage or loss of income due to malfunctioning of the product
TROUBLE SHOOTING BELT DRIVE TRAIN
SYMPTOM
runs, bolt slip,
squeak on
bolt
Belt runs
High amps, tripping.
blows fuses
Noisy or “clicking”
drivo
WINDSOR INDUSTRIES, INC.,
Belt slack
Belt worn or broken
Motor slide
drive pulley
Pulleys out alignment
-
belt tension too high
Seized or stiff pulley
bearings
Bearings or housings worn.
TEST
Stall test machine with
drive board glued or screwed
to floor
Remove belt slacken
mounting spring check for
free movement.
Check pulley alignment
Turn drive by hand
-
run
motor with belt removed.
Adjust belt tension correctly.
Check pulley alignment
before fitting new belt.
Ensure free movement in
guide over lull length.
Remove grease with solvent -
emery pulley surface.
pulleys. refit drive
not over tension.
Replace bearings.
Replace
-
CAUTION
The bearings are shrink
fitted. heat the pulley before
reassembly.
I
!
W. Stanford Ave., CO 80110 USA
2af