Western Telematic AT COMMAND SET MT9234 - Manual (Page 8)

2-2
MT5634/MT9234 Modem; AT Command Set
Command Description
\Bn Transmit Break
\Kn Break Control
\Nn Error Correction Mode Selection
\Qn Flow Control Selection
\Tn Inactivity Timer
\Vn Protocol Result Code
-Cn Data Calling Tone
%An Adaptive Answer Result Code Enable
%B View Numbers in Blacklist
%Cn Data Compression Control
%DCn AT Command Control
%En Fallback and Fall Forward Control
%Hn Direct Connect Enable
%Rn Cisco Configuration
%Sn Command Speed Response
$EBn Asynchronous Word Length
$Dn DTR Dialing
$MBn Online BPS Speed
$SBn Serial Port Baud Rate
#CBAn Callback Attempts
#CBDn Callback Delay
# CBF? Callback Failed Attempts Display
# CBFR Callback Failed Attempts Reset
# CBIn Local Callback Inactivity Timer
# CBNy=n Store Callback Password
# CBPn Callback Parity
# CBRy Callback Security Reset
# CBSn Callback Enable/Disable
#Pn Set 11-bit Parity
#Sx Enter Setup Password
#S=x Store Setup Password
+VDR=x, y Distinctive Ring Report
+++AT<CR> Escape Sequence
%%%ATMTSMODEM<CR> Remote Configuration Escape Sequence