White LC-436 - Manual (Page 8)

8
Attaching Side-Discharge Chute
Your lawn mower was shipped as a mulcher. Remove the mulching cover and attach the side-discharge
chute to discharge grass clippings.
• Lift the hinged mulching plug. Slide the two hooks on the side discharge deflector under the hinge
pin on the mulching plug assembly. See Figure 5. Lower the mulching plug.
FIGURE 5
IMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL. Be certain to service engine with
gasoline and oil as instructed in the separate engine manual before operating your mower.
Attaching Rear Bagger
• To convert your mower from a mulcher to a rear bagger, remove side-discharge and lower the side
mulching plug. For location of side mulching plug, see Figure 7.
• Lift the chute door on the mower. Remove the rear mulching plug. Place hooks, located on two sides
of the grass catcher frame, over the chute door pivot rod on the back of the unit. See Figure 6.
Release chute door.
FIGURE 6
• To remove the grass catcher, lift the chute door on the mower. Lift the grass catcher up, and off of
the pivot rod. Release the chute door.
Hinge Pin
Mulching Plug
Hook
Deflector
(Slide hooks under the two
sides of hinge pin)
Chute Door
Rear Discharge
Grass Catcher
Rear Mulching
Plug