West Bend Blender - Manual (Page 5)

Assembling Your Blender
Before assembling your blender wash all loose parts in warm soapy water, rinse
thoroughly and dry.
Cover Centerpiece
Cover
Jar
Blade
Base Unit
Control Knob
Rubber Seal
Jar Locking Base
Using Your Blender
1. Place appliance on dry, level, heat-resistant surface, away from any edge.
NOTE: Do not operate blender where dust or flour can be sucked up into the
vent openings, as this will cause damage to the blender.
2. Plug cord into a 120 volt AC electric outlet only.
3. Put liquids into the blender first unless recipes call for an alternate processing
sequence.
4. Prepare ingredients for blending. Cut all solid ingredients, i.e. fruits, vegetables,
or cheeses or meats into uniform pieces, ½ to 1-inch cubes. Place cover on
blender. NOTE: Always place one hand on jar or jar cover to steady blender
wihile operating.
5. Blend foods according to the recipe or until the desired results are achieved.
NOTE: If scraping or stirring of contents is required, turn blender to the “off”
position and unplug from electrical outlet. Use only a flexible spatula so
scratching of glass does not occur.
•
A small amount of odor may occur during operation due to the release of
manufacturing oils – this is normal.
5