Williams Sound PPA T35 - Manual (Page 4)

© 2011, Williams Sound, LLC CAT 099F
Domestic Sales
Williams Sound
10300 Valley View Rd
Eden Prairie, MN 55344
Ph: 800-328-6190 / 952-943-2252
FAX: 952-943-2174
Email: [email protected]
Web: www.williamssound.com International Sales
International Sales Department
Williams Sound
10300 Valley View Rd
Eden Prairie, MN 55344 USA
Phone: +1 952 943 2252
Fax: +1 952 943 2174
Email: [email protected]
Web: www.williamssound.com
800.843.3544 / [email protected] / www.williamssound.com
Personal PA ™ FM Transmitter
NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE!
*DISCLAIMER: FCC RULES LIMIT USE OF THIS EQUIPMENT TO AUDITORY ASSISTANCE
Bid Specs
PPA T35
The PPA T35 transmitter shall be microprocessor controlled with
push button configuration. It shall have an operating range of up to
1000 feet. It shall have 10 wideband and 7 non-standard wideband
channels operating on 72.1–75.9 MHz. It shall have 77 narrowband
channels operating on 72.025–75.975 MHz.
Front Panel:
The PPA T35 shall have a push button controlled LCD digital display.
There shall be three pre-configured (selectable) application presets:
Hearing Assist, Music and Voice. Configurations for Bandwidth,
Frequency, Audio Input Source (Microphone, Line, Simplex), High
Pass Filter, Low Pass Filter, Compressor Slope, Compressor Gain
and RF Output Power shall be push button controlled. The audio
level shall be adjustable by push button control. There shall be a 10
LED array showing +9 to -18 at 3dB intervals. The PPA T35 shall
have a 1/4” phone jack with push button volume control. It shall
have push button control for monitoring source audio or transmitted
audio. It shall have an input overload indicator. It shall have an “on”
indicator and power button.
Rear Panel:
The PPA T35 shall be powered by 24 VAC power supply via a 3-pin
Molex
® connector. It shall have a 75 ohm
F-connector antenna. It shall have an ANT 025 whip antenna on the
top panel directly connected to the circuit board. The transmitter
shall have an RCA line output jack. It shall have a combination 1/4”
phone/XLR audio input jack. It shall have an RF “Off” timer that turns
off RF signal after 1 hour of no audio activity.
The PPA T35 shall have FCC, RoHS, and WEEE approval and be
powered by UL and CSA power supply. It shall have a 5-year parts
and labor warranty. It shall be compatible with Williams Sound FM
equipment operating on 72-76 MHz. The transmitter shall be a
Williams Sound. model number PPA T35.