Wilton 1230 - Manual (Page 13)

13
release it. Rather, the lever stays in the position in
which you put it when you are controlling the spindle.
There is no need to hold it in position to keep the
spindle running. All of these functions are clearly labeled on the
plate which surrounds the control lever and boot.
Periodic maintenance
The only maintenance for the Model 1230 is
lubrication and changing of the coolant according to
the schedule, below.
Item Location Action Interval Lubricant
Oiling cup Top and bottom of arm Add lubricant with lube gun Daily Mobil Vactra oil AA
at column
Oiling cup Top of drill head Add lubricant with lube gun Daily Mobil Vactra oil AA
Oiling cups Right hand side of Add lubricant with lube gun Daily Mobil Vactra oil AA
drill head
Arm raising Rear of column Oil using lube gun Daily Mobil Vactra oil AA
worm
Sight glass
On drill head Check for level -- fill through Daily Mobil Vactra oil AA
pipe plug hole top of drill head
Lift chains On rear of arm Lubricate with lube gun Weekly Mobil Vactra oil AA
Ways On arm Lubricate with lube gun Twice daily Mobil Vactra oil AA
Coolant In tank Monitor for cleanliness When cutting
and efficiency. Replace when
dirty or when cutting becomes
inefficient
Oil fitting On quill Lubricate with gun Daily Mobil Vactra oil AA
Rack On arm Lubricate with gun Every 3 days Mobil Vactra oil AA
Figure 4: Lubrication diagram