Wind Crest CTG365D - Manual (Page 4)

4
SAFETY PRACTICES TO AVOID
PERSONAL INJURY
IMPORTANT SAFETY INSTRUCTIONS
THE RISK OF FIRE,
ELECTRIC SHOCK OR
INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Use this unit only in the
manner intended by the
manufacturer. If you have any
questions, contact the
manufacturer.
B. Before servicing or cleaning
unit, switch power off at
service panel and lock service
panel to prevent power from
being switched on
accidentally.
WARNING
– TO REDUCE
THE RISK OF SHOCK, OR
INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Keep exhaust hoods, filters
and grease-laden surfaces
clean.
B. Always turn hood ON
when cooking at high heat.
C. Use high range settings on
range only when necessary.
Heat oil slowly on low to
medium setting.
D. Do not leave range unattended
when cooking.
E. Always use cookware and
utensils appropriate for the
type and amount of food
being prepared.
WARNING
– TO REDUCE
THE RISK OF INJURY TO
PERSONS, IN THE EVENT OF
A GREASE FIRE, OBSERVE
THE FOLLOWING:
A. SMOTHER FLAMES with a
close-fitting lid, cookie sheet,
or other metal tray, then turn
off the gas burner or the
electrical element. BE
CAREFUL TO PREVENT
BURNS. If the flames do not
go out immediately
EVACUATE AND CALL
THE FIRE DEPARTMENT.
B. NEVER PICK UP A
FLAMING PAN
– You may
be burned.
C. DO NOT USE WATER,
including wet dishcloths or
towels
– a violent steam
explosion will result.
D. Use an extinguisher ONLY if:
1. You know you have a
class ABC extinguisher,
and you already know
how to operate it.
2. The fire is small and
contained in the area
where it started.
3. The fire department is
being called.
4. You can fight fire with
your back to an exit.
*************************************************************************************************
When properly used and cared for
your new Wind Crest Cooktop has
been designed to be a safe, reliable
appliance. When using kitchen
appliances, basic safety
precautions must be followed,
including the following:
Read this Use and Care annual
carefully before using your new
cooktop to reduce the risk of fire,
electric shock, or injury to persons.
Begin by insuring proper
Installation and servicing. Follow
the installation instructions
provided with this product. Have
the cooktop installed and grounded
by a qualified technician. Have
the installer show you where the
gas shut-off valve is located so that
you know how and where to turn
off the gas to the cooktop.
If you smell gas, your installer has
not done a proper job of checking
for leaks. Connections can loosen
in transit. If the connections are
not perfectly tight, you can have a
small leak and therefore a gas
smell. Finding a gas leak is not a
“do-it-yourself” procedure. Some
leaks can only be found with the
burner control in the ON position.
For proper lighting and
performance of the burners, keep
the igniters clean. It is necessary
to clean these when there is a boil
over, or when the burner does not light even though the electric
igniters click. See cleaning and
general care section.
The cooktop is factory assembled
for natural gas. It should be
correctly adjusted by a qualified
service person or installer for the
type of gas with which it is used.