weber 42376 - Manual (Page 4)

4
LOCATING YOUR BUILT-IN SIDE BURNER
When determining a suitable location for your Built-In Side Burner installation,
give attention to concerns such as exposure to wind, proximity to traffi c paths,
and keeping any gas supply lines as short as possible. Never locate the Sum-
mit
®
Built-In Side Burner in a garage, breezeway, shed, under an unprotected
overhang, or other enclosed area. Locate the Side Burner and structure so
there is enough room to safely evacuate the area in case of a fi re.
CLEARANCE FROM COMBUSTIBLE SURFACES OR
STRUCTURES
ƽ WARNING: Clearance from the outside walls of the
sides and back of the LP Tank Cabinet must be a minimum
of 24 inches any surface. Refer to “Typical Gas Supply
Installation” before starting installation.
ƽ WARNING: The structure, “island” counter tops and
adjacent work areas for the LP Tank Cabinet installation
must be built from noncombustible materials only.
NOTE: If you have questions on what materials are considered
noncombustible, contact you local building supplier or fi re department.
An
y Surf
ace
An
y Surf
ace
24 inches Any Surface
24 inches 24 inches
Note: For a countertop
treatment: Recommended
3/4 inch overhang. Notch
front edge for frame to
fully slide in.
Side
Burner
24 inches min.
for lid clearance
BUILT-IN SRUCTURE CUTOUT DIMENSIONS
All dimensions are to fi nished surfaces.
ƽWARNING: All counter top fi nished surfaces must be
constructed of a noncombustible material.
GAS INSTRUCTIONS
Side Burner
Cut out Dimensions Tolerances
A 10 1
2
" + 1/4 " - 1/4 "
B 3 3/4 " + 1/4 " - 1/4 "
C 16 1/4 " + 1/4 " - 1/4 "