Windsor TRACER FS QTFSD - Manual (Page 27)

MAINTENANCE
QTFSG/QTFSD 98349 05/15/03
4-10
REPLACING THE LEFT BROOM SKIRT
1. Turn off machine and set parking brake.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, apply parking brake, turn off
machine and remove key.
2. Raise rear cover and disconnect the batteries
from the machine.
3. Open the left broom door.
NOTE: The left skirt is mounted to the frame. This
skirt does not have a wear indicator strip.
4. Remove the five adjustment nuts and the
retaining bars.
5. Replace the worn side skirt with a new skirt.
6. Install the retaining bars and adjustment nuts.
7. Adjust the side skirt.
ADJUSTING THE LEFT BROOM SKIRT
1. Turn off machine and set parking brake.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, apply parking brake, turn off
machine and remove key.
2. Raise rear cover and disconnect the batteries
from the machine.
3. Open the left broom door.
NOTE: The left skirt is mounted to the frame. This
skirt does not have a wear indicator strip.
4. Loosen the five adjustment nuts.
5. Adjust the side skirt for correct floor clearance,
then tighten the adjustment nuts.
6. Tighten the five broom skirt.
7. Adjust the rear skirt.
ADJUSTING THE REAR BROOM SKIRT
1. Turn off machine and set parking brake.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, apply parking brake, turn off
machine and remove key.
2. Loosen the five upper adjustment nuts on the
rear skirt mounting plate.
3. Adjust the rear skirt for correct floor clearance,
then tighten the adjustment nuts.
RECIRCULATION SKIRT
The recirculation skirt helps to channel debris that
has been carried over the main broom, back into the
sweeping area. The recirculation skirt should be
checked daily for wear or damage.
REPLACING THE RECIRCULATION SKIRT
1. Turn off machine and set parking brake.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, apply parking brake, turn off
machine and remove key.
2. Raise the rear cover and disconnect the
batteries from the machine.
3. Remove the main broom.
4. Open the left broom door.
5. Remove the three retaining nuts and retaining
strip on the left side broom skirt.
6. Loosen the five retaining nuts on the
recirculating skirt retaining plate.
7. Slide the worn skirt out of the skirt retainer and
replace with a new skirt.
8. Hold the skirt firmly in place and tighten the five
retaining bolts. No adjustment is required.