Wolfgang Puck CHEFSERIES CIBC1000 - Manual (Page 3)

5
Assembly and Use of
H Haanndd B Blleennddeerr Attachment
1. Ensure the motor base is unplugged. Attach hand blender
rod to motor base by lining up the two separate parts. Turn
clockwise to lock in place.
2. Place one of the small metal attachments in the shaft of the mixing
rod. Make sure that the pin located on the shaft fits into the slot of
the attachment. Press down until attachment locks in place.
Caution: Blades are sharp. Handle with care.
3. Place food in suitable container for mixing (beaker, bowl, pan). For
best results, solid foods should be no larger than 1/4" or 1/2” cubes.
4. Plug into 120-volt 60 Hz AC only outlet.
5. Place the hand blender attachment into your ingredients.
Turn the speed selector to LO first. Press the ON/OFF
switch to begin blending; then gradually increase speed,
as needed. Slowly move the blade up, down and sideways
through the food . Note: Never lift the hand blender attachment
out of your ingredients while the unit is running.
6. Do not operate the motor continuously for more than one
minute when using hand blender attachment. Allow it to
cool off for 3 minutes before next use.
7. When you are finished, simply release the ON/OFF
switch, unplug the motor base, and then unscrew the hand
blender rod.
11
Know Your Immersion Blender/Chopper
4
1. Motor base
2. ON/OFF switch
3. Speed selector
4. Blending rod
5. Mixing beaker
6. Stand
7. Screws for wall mount
8. Attachment removal tool 9. Grinder blade
10. Multipurpose blade
11. Aerator disc
12. Blender disc
13. Bowl cover
14. Chopping blade
15. Blade shaft
16. Chopper bowl
3
8
13
2
1
5
6
4
7
10
9
14
12
16
15