Water Boss 900 - Manual (Page 6)

SOME DO'S
1. Do comply with all local plumbing and electrical codes.
2. Do install pressure-reducing valve if inlet pressure exceeds 90 psi.
3. Do install gravity drain on salt storage cabinet. See figure 7.
4. Do secure drain line on appliance and at drain outlet. See figure 3.
5. Do allow a minimum of 8 to 10 feet of 3/4” pipe from the outlet of the water conditioner
to the inlet of the water heater. See figure 1.
SOME DON’TS
1. Do not install if checklist items are not satisfactory.
2. Do not install if incoming or outlet piping water temperature exceeds
120 degrees Fahrenheit. Please see specification on page 25.
3. Do not allow soldering torch heat to be transferred to valve components or
plastic parts. See Installation Tip, page 6.
4. Do not overtighten plastic fittings.
5. Do not place appliance right up against a wall which would deny access to
plumbing. See figure 1.
6. Do not install the appliance backwards. Follow arrows on inlet/outlet.
See figure 2.
7. Do not plug the transformer into an outlet that is activated by an on/off switch.
See figure 8.
8. Do not connect the drain and the overflow (gravity drain) together.
See figure 1.
4
Do’s And Don’ts
When calling the HelpLine, please have this guide and the serial number
available. From 8 am to 5 pm EST, call 1-800-437-8993.
Your serial number may be found on top of your valve assembly.