Wayne-Dalton 3750-372 - Manual

Wayne-Dalton Corp.
P.O. Box 67 Mt. Hope, OH 44660
(888) 827-3667
www.wayne-dalton.com
Opener Models:
Torsion idrive ® models: 3651-372, 3750-372.
Prodrive ™ /Quantum ® /Classicdrive ® models: 3220C, 3221C, 3222C, 3224C, 3320B, 3322B, 3324B,3012, 3014, 3016, 3018,
3211, 3212, 3213, 3214, 3312, 3313, 3314, 3316, 3412, 3414, 3512, 3514.
DoorMaster ™ models: BDOR-2000 & BIRW-2000
idrive ® models: 3660-372, 3661-372, 3662-372, 3760-372, 3751-372.
Photoelectric Safety Sensors
Installation Instructions
and Owner’s Manual
© Copyright 2007 Wayne-Dalton Corp. Rev2 7/10/2007
Important Notice!
DOOR OPENER WILL NOT OPERATE PROPERLY UNTIL PHOTOELECTRIC SENSORS ARE INSTALLED AND
PROPERLY ADJUSTED! DO NOT OPERATE DOOR OPENER UNTIL IT IS FULLY INSTALLED, ADJUSTED AND
YOU ARE INSTRUCTED TO DO SO!
Photoelectric Sensors: 318873
(1) Sender w/Wire
(1) Receiver w/Wire
Photoelectric Sensors Hardware: 297218
(2) 5/16 x 1-1/2” Lag Screws
(2) 1” Flat Head Nails
(2) 1/4-20 x 1/2” Carriage Bolts, Washers & Nuts
(2) Wall Mounting Brackets
(2) “U” Brackets
(1) Power Cord Clip (adhesive back)
(1) Jumper
Part No: 306736
WIRES ARE
PRE-ATTACHED
Photoelectric Sensor Kit: 252118