West Marine VHF200 - Manual (Page 3)

West Marine VHF200 Owner’s Manual 3
Fig. 1: Power On Display
LCD Display
MEM Shown when channel is in scan
memory (page 14)
STEP Shown when radio is in STEP
mode (page 15)
TRI Shown when Triple Watch has
been selected (Page 12)
WX Shown when radio is in Weather
(WX) Mode (page 9)
ALERT Shown when radio is in Weather
Alert Mode (page 10)
LCD Description
USA/INTERNATION-
AL/CANADIAN (UIC)
Mode display (page 5)
Channel Number
display (page 4)
Battery Level display
indicator (page 8)
Radio Status Display; shows long and short channel
descriptions, warnings, and radio information (page 5)
M Shown when medium transmit
power is selected (page 7)
L Shown when low transmit
power is selected (page 7)
LOCK Shown when keypad is locked
(page 16)
TX Shown when transmitting (page
6)
BUSY Shown when radio is receiving a
signal (page 3)
1. Turning the Radio On
Turn the Power/Volume Knob clockwise
until it clicks. The radio will power up in
the same condition as it was last used.
The last Channel Mode (USA/INT/CAN),
Channel, TX Power, Key Lock, Squelch
Level, etc. are restored. The Radio Status
Display will show POWER ON. (Fig. 1)
2. Adjusting the Volume
Turn the Volume Knob clockwise to
increase volume and counterclockwise to
decrease volume.
WM-200 Manual v7 12/18/02 2:21 PM Page 3