Wasp Bar Code WPS100 - Manual (Page 121)

7-1
Chapter 7
Symbologies
Introduction
This chapter describes all symbology features and provides the programming bar codes
necessary for selecting these features for your WPS100 scanner. Before programming,
follow the instructions in
Chapter 1, Getting Started .
Your scanner is shipped with the settings shown in the Symbology Default Table on page
7-3 (also see Appendix A, Standard Default Parameters for all host device and
miscellaneous scanner defaults). If the default values suit your requirements, programming
may not be necessary. Features values are set by scanning single bar codes or short bar
code sequences.
To return all features to their default values, all you need to do is scan the Set All Defaults
bar code on page 4-5.
If you are not using a USB cable you must select a host type. Refer to each host chapter
for specific host information.