Whynter SNO ICE-100S - Manual (Page 4)

Installation Instructions
1) As with all refrigeration equipment, this appliance should be settled
for at least five hours prior to switching on the appliance.
2) The power supply must be an earthed 110V AC 60Hz mains supply.
1) Choose your required water supply method:
a. Water line supply - Use the provided water hose (17) to connect to
your household water supply (Fig. 1). If assistance is required,
please contact a certified plumber. Connect the water hose
connector to a water faucet. Place the other end of the water hose
into the water line connector (11) (Fig. 2) at the back of the unit.
To disconnect the water hose connector from the water spigot, first
make sure the water line is turned off, then simply pull back the
release washer of the connector and pull apart (Fig. 3). To release
the water line from the unit, simply unscrew the water hose on
water line plug and pull the hose out (Fig. 4)
b. Manual water filling – You can use tap water or purified water.
Remove the manual water fill compartment cover and place the
filter net (19) in the compartment, pour water into the
compartment until the compartment is full. Please ensure that
you do not overfill or allow the water level to drop below the
minimum level.
c. Commercial water bottle - Place a 3 or 5 gallon water bottle on
the top of the unit using the water bottle adapter. We do not
recommend using a water bottle with cap. To install the bottle
supporter, insert it to the manual fill compartment (10 with the
arrow pointing to the front of the unit. Turn the adapter clock wise
slightly until the tabs on the inside of the compartment match up
with the grooves on the protruding tube at the bottom of the
adapter. Push down and then turn counter-clockwise to lock the
adapter in place. Then sit the water bottle upside down to the
bottle supporter.
IMPORTANT – DO NOT turn on the unit before installing
the water bottle.