Warwick X7220 - Manual (Page 11)

Address Mode
Not used
TX Address Not used
RX Address
Not used
Restore Defaults
Set Factory Defaults.
Exit without Save Return to Modem
Advanced Menu
Return to Main Menu
Display Main Menu by pressing the left Arrow Key
Enable AT Instructions
Not used
TX
Priority Not used
Mode of Operation
Selects one of the following: Modem 1 in continuous use,
Modem 2 in continuous use
Modem 1 and Modem 2 cycling on the set Duty Cycle
Duty Cycle
Selects the time in hours for each modem to be operational. (1 to 48 Hr)
Packetise Data
Not used
Number of Retries
Not used
Enable Remote Access
Not used
Alarm code
One of the following alarm codes are displayed:
No fault 00
Bit error rate high 1 11
PSU fail 1 12
RF power fail 1 14
Bit error rate high 2 21
PSU fail 2 26
RF power fail 2 24
Dual RF power fail 75
Dual PSU 73
Engage Rpt Path
Not used.
Set Repeater Path
Not used