Wacom DTF-720 - Manual (Page 10)

Your new DTF-720
Page 8
INTERACTIVE PEN DISPLAY COMPONENTS
Your product has many features and components with which you will want to become familiar.
FRONT VIEW
The display and tablet sensor function as an integrated output and input device. The display supports
resolutions up to 1280 x 1024 pixels at 16.7 million colors. The tablet sensor reports pen coordinates,
pressure, and switch information.
On Screen Display (OSD) controls
These controls, located on the upper
edge of the tablet, enable you to adjust a
variety of display settings. See Adjusting
the display on page 28 for more
information.
Power LED
Lights blue when power has been supplied to the DTF-720
and a video signal is present.
Glows orange when no video signal is detected by the
DTF-720. (e.g., Your computer is turned off, starting up, or
has entered a power management mode in which video
signals are not sent.)
Power switch
Turns power to the unit on or off.
Status LED
Lights blue when the pen is in
the active area of the pen
display tablet and the pen tip
is pressed. Note that the USB
cable must also be plugged
into an active USB port before
the LED will light.
Integrated display and tablet
Use the integrated USB
ports (one located on each
side of the unit) to connect a
USB device (e.g., a USB
Flash Drive or a USB remote
controller).
Be sure to fully install the DTF-720 hardware and software before connecting any other devices to the unit.
DTF720_Manual.fm Page 8 Monday, December 22, 2008 9:17 AM