Dish receiver setup – Winegard Carryout Automatic Portable Satellite TV Antenna GM-1518 User Manual
Page 4
Carryout Antenna 6
5 Carryout Antenna
DISH Receiver Setup
DISH Receiver Setup
Select Test.
It will go through a number of
steps, then return to the screen
shown here with previous
information cleared.
If at any point it asks you to save,
select Save or Yes.
Reconnect the coaxial cable to the “Sat In” port on back of receiver. Now turn on
the antenna. Allow it 3–4 minutes to acquire satellites.
If setting up a DISH 311, 301, or 500 series receiver, in some cases you may need
to check the boxes next to Superdish and Alternate before running the Check
Switch test. Then, select Test and continue with normal receiver setup.
Select option 1, Point Dish.
Before turning the Carryout antenna on, follow the steps
below to clear out any existing receiver settings. If your
receiver differs from the options shown, you may need to
consult your receiver manual. The wording and display used
in your receiver may differ slightly.
For help, email [email protected] or call 1-800-788-4417
Before starting, disconnect coax
cable from “Sat In” on back of
receiver. Press Menu on your
remote. Select option 6, System
Setup.
Select option 1, Installation.
Disclaimer: Receiver setup instructions are accurate at time of printing and may change without
notice. Call Winegard tech line for assistance: 1-800-788-4417.
Select Check Switch.
Check that there are no
checkmarks by SuperDISH or
Alternate.
Next, select Test again.
This time it will install the
SW64 switch. This SW64 switch
is a DISH receiver setting, not a
physical part.
When you see the SW64 as the
installed switch, the antenna is ready for use.
SW64
6
5
4
3
2
1