Weider WESY13820 - Manual (Page 12)

12
24. Wrap the Low Cable (37) around a Pulley (39).
Attach the Pulley inside the bracket on the Base
(1) with an M10 x 45mm Bolt (68) and an M10
Nylon Locknut (56).
25. Wrap the Low Cable (37) around a Pulley (39).
Attach the Pulley and a Cable Trap (41) to the
second set of holes from the bottom of the two
Pulley Plates (14) with an M10 x 48mm Bolt (77)
and an M10 Nylon Locknut (56). Be sure the
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
23. Wrap the Low Cable (37) around a Pulley (39).
Attach the Pulley and a Cable Trap (41) to the
lower set of holes in the “U”-Bracket (81) with an
M10 x 48mm Bolt (77) and an M10 Nylon Locknut
(56).
56
81
37
41
77
39
23
39
37
56
68
1
24
41
39
37
56
25
77
14
26. Attach the Low Cable (37) inside the Base (1)
with an M10 x 65mm Bolt (79), two M10 Washers
(55), two M10 x 23mm Spacers (83), and an M10
Nylon Locknut (56).
1
37
56 55
55
83
83
79
26