Whirlpool FREEZERATOR CONVERTIBLE REFRIGERATOR/FREEZER - Manual (Page 8)

8
6. Place the convertible refrigerator/freezer on its side on top of the
cardboard or protective material. Make sure the door hinge is
facing upward.
IMPORTANT: It is important that the door hinge face upward
during the entire caster installation.
7. Remove the casters and fasteners from the box.
8. Locate and remove the caster brackets from the FeaturePak.
9. Using ⁵⁄₁₆ –18 x ⁷⁄₈" hex-head bolts, attach one rigid caster and
one swivel caster to each caster bracket. The rigid caster fits the
front of the bracket and the swivel caster fits on the rear.
10. Insert the hex-head bolts from the bottom and start the self-
locking nuts for each caster.
11. Hold the head of the hex-head bolts with a wrench while
tightening the self-locking nuts with a socket wrench.
12. Using a ¹⁄₂" socket wrench, remove the four unit bolts (two on
each side) from the lower front and rear of the convertible
refrigerator/freezer.
NOTE: Do not remove leveling bolt.
Lower Front Corner
13. Place the slot in the rear of the caster bracket over the hole in the
rear of the convertible refrigerator/freezer. Align the hole in the
front of the caster bracket with the hole in the front of the
convertible refrigerator/freezer.
Lower Rear Corner
14. Hold the bracket in place and insert the unit bolts into the front
and rear unit holes and tighten.
NOTE: Do not overtighten the bolts.
15. Insert two of the ¹⁄₄–20 x 1¹⁄₄" hex-head bolts and lock washers
into the two holes in the side of the caster bracket. Push the
caster bracket against the bottom of the convertible refrigerator/
freezer and tighten the bolts using a
³⁄₈" socket wrench.
16. Repeat steps 12 to 15 for the second caster bracket.
A. Top hinge
B. Center hinge
A. Self-locking nut
B. Caster bracket C.
⁵⁄₁₆
–18 x
⁷⁄₈
" Hex-head bolt
D. Caster