Wind Crest CTI304D - Manual (Page 3)

Page 3 of 8 11067.00 Rev B
MIN
IMU
M C
ABI
NET
WID
TH
= CO
OKT
OP W
IDT
H
TOP FOR
BEYOUND WIDTH
OF COOKTOP
EXTENDING
COMBUSTIBLE
FRO M COUNTER
18" MINIMUM
SURFACES
CABINET
MINIMUM
CLEA RANCE
SIDE WALL
= 1"
MAXIMUM
D EPTH = 13"
A
MINIMUM CLEARANCE
FROM BACK OF EXTRUSION
TO BACKSPLASH = 2"
CLEARANCE TO COMBUSTIBLE SURFACES
– A=30 inches minimum clearance between the countertop
and the bottom of an unprotected wood or metal cabinet.
A = 30 inches minimum clearance between the top of the cooking surface and the bottom of an unprotected wood
or metal cabinet or A = 24 inches minimum when the bottom of wood or metal cabinet is protected by not less than
1/4 inch thick flame retardant material covered with not less than #28 gage sheet steel, .015 inch thick stainless
steel, .024 inch thick aluminum, or .020 inch thick copper.
Flame retardant materials bear the mark:
UNDERWRITERS LABORATORIES INC.
CLASSIFIED
MINERAL AND FIBER BOARDS.
SURFACE BURNING CHARACTERISTICS
This mark is followed by the flame spread and smoke ratings. These designations are shown as “FHC (Flame
Spread)/(Smoke Dev
eloped)”. Material with “0” flame spread rating are flame retardant. Local codes may allow
other flame spread ratings.
The minimum horizontal clearance from the sides and back of the cooktop to the adjacent vertical combustible
walls is 1 inch on sides and 2 inches on back.
COUNTERTOP CUTOUT DIMENSION
– Always consult the countertop manufacturer for specific installation
instruction or requirements. Note: Counter top opening must
accept square corners of cooktop.