Wadia Digital 830 - Manual (Page 12)

PLAY: Pressing play causes the unit to begin playing. If the drawer was opened, the unit will
close the drawer, and then begin playing.
STOP: Pressing stop causes the disc to stop playing.
PAUSE: Pressing pause suspends playing until play is pressed, or until pause is pressed again
VOLUME UP and VOLUME DOWN: Pressing these increases or decreases volume by 0.5 dB. The
LED bar graph on the front panel indicates the volume level, with one light illuminating
for every 5 dB increase in volume. At the maximum volume level, only the top volume light
is illuminated.
NEXT TRACK/PREVIOUS TRACK: Pressing these keys skips to the next, or previous track.
DRAWER OPEN/CLOSE (O/C): O pens and closes the CD loading drawer.
INVERT*: The Wadia 830 has the ability to invert absolute phase in the digital domain. Pressing
the Invert key on the remote control will cause the Wadia 830 to invert phase; pressing it again
will switch the phase back to normal. When the phase is inverted, the PHASE LED will illuminate
on the front panel.
MUTE*: The Wadia 830 Compact Disc Player has two mute modes that are automatically
implemented under different circumstances. Note that CD will continue playing even when
the output is muted.
Software Mute: When the Mute key is pressed on the remote control, the Wadia 830
Compact Disc Player’s DSP engine transmits a stream of zero signal level samples to the DAC
section, which results in zero output.
Relay Mute: The Wadia 830 Compact Disc Player has mute relay connected between the
positive and negative outputs. When this relay is engaged, it connects the positive output to
the negative output, reducing the output to zero. This relay, which produces an audible click
when it engages or disengages, is not in the music signal path. The mute relay is engaged:
1. When the Wadia 830 Compact Disc Player detects AC input level below its minimum
operating range.
2. Each time the Wadia 830 Compact Disc Player power switch is turned on.
3. When the volume control is set to zero AND the mute key on the remote control
is pressed.
When the Wadia 830 is in either Mute Mode, the Mute LED will illuminate.
REPEAT*: Pressing this button will cause the disc to repeat continuously. Pressing it twice will
repeat the current track continuously. Pressing it a third time will stop repeating. The repeat
mode is indicated by the front panel LED’s
INPUT’: The Wadia 830 Compact Disc Player can be configured with four digital inputs,
in addition to the internal CD drive (See section on Optional Inputs). Each time the input key
is pressed, the next input is selected. For example, if you are listening to the internal CD drive,
and you press the input select, Input 1 will be selected, press it again, and Input 2 will be selected
and so on. After Input 4, the list will begin again with the CD drive.
SEARCH FORWARD/BACKWARD*: Pressing and holding these keys will speed forward or
backward within the current track.
*These functions are available on the remote control only.