WorldSpace Radio TONGSHI - Manual (Page 9)

1) Access Radio ID and Setup Password:
When turn into a pay channel, appears on the LCD display. To
receive it, you need to have a subscription agreement with the services
provider and get a set of password (22 or 25 digits number). This
function can be achieved by the following operations:
When the power is on,
Press and button simultaneously to list ID of the Radio. ♦
Press into password entry mode. ♦
Press or button to add or subtract the current digit. ♦
Press to skips to the next digit. ♦
Note: Press aborts the password entry mode.
2) Setup ANT Type:
There are three types of WS ANT called LINEAR, CIRCULAR and CABLE.
You must setup up the correct ANT type used for Radio. If you don’t
know which ANT type used, please refer to the label stuck on ANT back.
Setup ANT type can be achieved by the following operations:
When the power is off,
Press button and hold it, then turn on Radio. ♦
Press button to skip ANT type from Circular, Cable and Linear. ♦
Press button to save present ANT type and return. ♦
Note: Press cancels ANT setup mode.
Warning: All programs in LIST will be cleared after ANT type changed.
3) Setup BATT Type:
There are two types of batteries for Radio, called Ni-MH and Alkaline. In
order to show batteries volume correctly, you must select the right type
of batteries. This setup can be achieved by the following operations:
When the power is off,
Press button and hold it, then turn on Radio. ♦
Press button to skip BATT type from NiMH and Alka. ♦
Press button to save present BATT type and return. ♦
4) Setup Autopower Function:
If batteries are used and no key or button pressed for 12 minutes,
Radio will beep every 4 seconds for ten times. If no key or button are
pressed, Radio will be turned off automatically for power saving. This
function can be enabled or disabled by the following operations:
When the power is off,
Press button and power on the Radio. ♦
Press button to skip Autopower from ON to OFF. ♦
Press button to save and return. ♦
9