Westinghouse WST1500-1509 - Manual (Page 5)

CLEANING TOOLS
The Westinghouse WST1500 Vacuum Cleaner comes with 3 On-Board Cleaning Tools
and a Tool Holder.
Floor Nozzle
Use the Floor Nozzle to clean low, hard-to-reach spaces, under furniture, where dust and dirt
accumulate. It's also a great way to clean stairs. Good for bare floor surfaces.
Dusting Brush
The Dusting Brush has short, soft bristles to remove pet hair, lint and fine dust particles. Use it
to clean drapes, blinds and upholstered furniture.
Crevice Tool
The Crevice Tool is a long narrow tool with a rounded larger end and a flat tapered end. Use to
reach and clean difficult nooks and crannies between furniture and appliances, along baseboards
or under cabinets where cobwebs, lint and dust like to hide.
Cleaning Tools Storage
Each Tool has its own special storage spot on
board the Vacuum Cleaner. The Floor Nozzle
and the Crevice Tool fit in the Tool Holder.
The Dusting Brush has its own Mounting
Peg. (See Figure 1a.)
1. Locate the Tool Holder Mounting Post
on the bottom left side of the
Vacuum Cleaner.
2. Position the Tool Holder so that the
dome-shaped cylinder fits right on top of
the Mounting Post. (See Figure 4a.)
3. Slide and press the Tool Holder down to
secure it into place.
4
Figure 4a
Figure 3b
Dusting Brush
(P/N 40023)
Figure 3c
Crevice Tool
(P/N 40015)
Figure 3d
Tool Holder
(P/N 40021)
Figure 3a
Floor Nozzle
(P/N 40022V)
Tool
Holder
Mounting
Post
WST1500-1509_IB_12-6-03 6/12/03 9:17 PM Page 5