Weider WEBE4496.0 - Manual (Page 9)

9
6. Insert the Backrest Bracket (6) into the slot in the
Frame (1). Next, apply a small amount of the
included grease to an M10 x 193mm Bolt (139).
Then, attach the Backrest Frames (7) to the
Frame with the Bolt, two M10 Washers (96), and
an M10 Nylon Locknut (94).
Do not overtighten
the Nylon Locknut; the Backrest must pivot
easily.
Insert a Short Pin (21) through the Frame (1) into
one of the adjustment holes in the Backrest
Bracket (6). Attach the Short Pin to the Frame
with an M4 x 16mm Self-tapping Screw (102).
Make sure the Short Pin is engaged in an
adjustment hole.
See the inset drawing. Insert an M8 x 22mm Bolt
(108) through the lower end of the Backrest
Bracket (6). Then, tighten an M8 Nylon Locknut
(97) onto the end of the Bolt.
See steps 4 and 5 and tighten the M10 Nylon
Locknuts (94) and the M6 x 39mm Screws
(107).
7. Attach the Seat (10) to the Frame (1) with two M6
x 16mm Screws (105), an M6 x 63mm Screw
(106), and an M6 Washer (98).
7
6
105
106
98
7
6
21
1
96
96
94
1
10
139
Grease
Slot
102
108
97 6
8. Apply grease to the barrel of an M10 x 64mm Bolt
Set (103). Attach the Leg Lever (5) to the bracket
on the Front Leg (4) with the Bolt Set.
Make sure
that the barrel of the Bolt Set is inserted
through both sides of the bracket on the Front
Leg.
8
4
5
103
Grease
Bracket
103