Caring for your air conditioner – Whirlpool ACE082XH0 User Manual

Page 10

Advertising
background image

10

1. Unplug air conditioner or disconnect power.

2. Remove the air filter and clean it separately.

(See “Cleaning the air filter,” above).

3. Open control panel door (some models).

4. Pull control knobs off.

5. Remove two screws from bottom of the front panel. Pull

panel out and away from the cabinet.

6. Clean front panel with warm water and mild soap or

detergent. Use a soft cloth.

7. Rinse control panel and dry thoroughly with a soft, dry cloth.

8. Insert top of panel into cabinet, then push bottom of panel

into cabinet. Replace screws. Replace control knobs. Close
control panel door (some models).

NOTE: Route power supply cord through notch in front panel.

Make sure power supply cord does not interfere with
front panel screw.

9. Plug in air conditioner or reconnect power.

Your new air conditioner is designed to give you many years of dependable service. This section tells you how to clean
and care for your air conditioner properly. Call your local authorized dealer for an annual checkup. Remember… the cost
of this service call is your responsibility.

The air filter is removable for easy cleaning. A clean filter helps
remove dust, lint, and other particles from the air and is
important for best cooling or heating and operating efficiency.
Check the filter every 2 weeks to see if it needs cleaning. Do
not operate the air conditioner without the filter in place.

1. Unplug air conditioner or disconnect power.
2. Put fingers in indents in top of filter door and pull door

down. Filter door is not removable.

3. Slide air filter up and out to remove from the filter door.
4. Use a vacuum cleaner to clean air filter. If air filter is very

dirty, wash it in warm water with a mild detergent. Do not
wash air filter in the dishwasher or use any chemical
cleaners. Air dry filter completely before replacing to
ensure maximum efficiency.

5. Slide air filter down into the filter door. Close filter door.
6. Plug in air conditioner or reconnect power.

Check once or twice a year for paint damage. This is
very important, especially in areas near oceans or
where rust is a problem. If needed, touch up with a
good grade enamel paint.

NOTE: To reduce paint damage during the winter,
install a heavy-duty cover over air conditioner cabinet.
For information on ordering a heavy-duty cover, see
page 18.

Caring for Your Air Conditioner

EN

Repairing paint damage

Cleaning the air filter

Cleaning the front panel

indents

Advertising