White Outdoor 693 - Manual (Page 11)

11
SECTION 6: CONTROLS
IGNITION SWITCH
The ignition switch is located on the dashboard. Turn
the key to the START position to start the engine.
When the engine is running, leave the key in the ON
position. To stop the engine, turn the key to the OFF
position. See Figure 10.
WARNING: Remove key from the
tractor when tractor is not in use to prevent
accidental starting.
THROTTLE CONTROL
The throttle control is located on the dashboard and
is used to regulate the engine speed. To get
maximum efficiency from cutting, the throttle should
be in the fast position when operating the mower.
See Figure 10.
Figure 10
CHOKE CONTROL
The choke control is located on the left side of the
dashboard and is operated manually. Details for the
choke operation are covered in the separate engine
manual packed with your unit. See Figure 10.
LIGHT SWITCH
The head lamps are operated by pushing the light
switch located on the dashboard. The head lamps
will only operate when engine is running. See Figure
10.
AMMETER
The ammeter registers the rate of battery charge or
discharge. The ammeter will register on the discharg-
ing side with starting the engine. It should register on
the opposite side (charging) when the engine is run-
ning in the fast position until the battery is completely
charged. With a fully charged battery or with the
engine idling, the ammeter will not show a charge.
See Figure 10.
HYDROSTATIC CONTROL LEVER
The hydrostatic control lever is located on top of the
fender on the right side of the tractor. This single con-
trol lever, connected to the hydrostatic transmission,
controls both the speed and direction of the tractor.
Infinite speed control is achieved by moving the con-
trol lever forward or backward. The farther forward or
backward you move the control lever, the faster you
will travel. Pulling the control lever into neutral (N)
area will stop the tractor. See Figure 11.
Figure 11
CLUTCH-BRAKE PEDAL
The clutch-brake pedal is located on the left side of
the tractor. See Figure 10. Depressing pedal returns
the drive unit to neutral (N) and applies the brake.
NOTE: The clutch-brake pedal must be depressed
to start the engine.
PARKING BRAKE
To set the parking brake, depress the clutch-brake
pedal, pull up the parking brake knob and release
the clutch-brake pedal. It will stay in the raised
position. To release the parking brake, depress and
release the clutch-brake pedal while pushing down
on the parking brake knob. See Figure 12.
NOTE: The parking brake must be set if the
operator leaves the seat with the engine running.
Figure 12
Light
Switch
Choke
Throttle
Control
Clutch-Brake Pedal
Ignition
Lift
Lever
Ammeter
Switch
Hydrostatic
Control
Lever
Parking
Brake
Relief
Valve
Knob