Weider WESY37530 - Manual (Page 19)

19
48. Wrap the Low Cable (63) over a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the second set of holes from the bottom of the
Double “U”-bracket (41) with an M10 x 48mm Bolt
(23) and an M10 Nylon Locknut (75). Make sure
the Cable Trap is turned to hold the Cable in
the groove of the Pulley.
51. Wrap the Low Cable (63) under a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the Press Frame (14) with an M10 x 120mm Bolt
(76) and an M10 Nylon Locknut (75). Make sure
that the Cable Trap is turned to hold the Cable
in place. Do not tighten the Locknut yet.
52. Wrap the Low Cable (63) around a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the Right Seat Frame (3) with an M10 x 120mm
Bolt (76) and an M10 Nylon Locknut (75). Make
sure that the Cable Trap is turned to hold the
Cable in place. Do not tighten the Locknut yet.
48
38
75
37
63
23
41
49. Wrap the Low Cable (63) under a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the Right Base (1) with an M10 x 48mm Bolt (23)
and an M10 Nylon Locknut (75). Make sure that
the Cable Trap is turned to hold the Cable in
place.
50. Wrap the Low Cable (63) over a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the Right Upright (5) with an M10 x 110mm Bolt
(90) and an M10 Nylon Locknut (75). Make sure
that the Cable Trap is turned to hold the Cable
in place. Do not tighten the Locknut yet.
49
75
38
63
37
23
1
50
51
52
75
63
37
38
90
75
14
38
37
76
63
75
3
38
37
76
63