Wyse Technology X90L - Manual (Page 12)

6
7. Install the new flash module in the reverse order of removing the old module.
8. To remove the existing RAM module, use your fingers to unlock the two locking clamps
at either side of the module by pushing the clamps in the direction of the arrows shown
in Figure 9. The module should pop up from its socket. Lift out the RAM module.
Note
Early 1-GB configurations had two (2) 512-MB DIMMs installed. Your mobile
thin client may or may not have a RAM module installed in this location; if it
does, then replace with one (1) 1-GB RAM module.
Figure 9 Removing the RAM module
9. Insert the new RAM module into the connector of the original module, and then press
down on the module so that the two locks will snap in place, securing the module.
10.Replace the cover and keyboard in the reverse order as shown in Figures 5 through 7.
11. Proceed to “Verifying the Mobile Thin Client’s Operation.”