603-750-0 pg3-1, Operations – Windsor PJ2AIE User Manual

Page 8

Advertising
background image

OPERATIONS

86037500 PJ2A 03/04/08

3-1


USING PILEJOGGER II WITH
EXTRACTOR


1. Connect vacuum and solution hoses to

PILEJOGGER.

2. Plug power cord into properly grounded

outlet.

3. Move PILEJOGGER to starting place. Turn

on brush drive motor by depressing foot
switch located on top of cleaning head.
Depress solution valve lever fully and move
backward at a steady pace (25 to 30 feet
per minute).
NOTE: Lift the handle slightly as you move
backward so the weight is almost off the
rear roller. This will bring the vacuum orifice
and brush into proper contact with carpet.

4. Release solution valve lever approximately

6 inches before reaching the end of the
cleaning pass to ensure that all solution is
extracted.

5. Make the next cleaning pass beside the

first, overlapping about 1 inch.

6. Reverse direction and clean balance of

room.
CAUTION: To prevent possible damage to
the carpet, never let the PILEJOGGER
stand in one place with the brush running.

Advertising
This manual is related to the following products: