Wacom PEN DISPLAY PL-521 - Manual (Page 19)

Working with your pen display
page 17
Pen operations
The basic methods of working with the pen are as follows:
Pointing and selecting: Move the pen above the DTF-521/PL-521 display screen to position the
screen cursor. The pen tip needs to be within 5 mm (0.2 inch) of the pen display tablet surface; you do
not need to touch the tablet surface to move the screen cursor. The cursor jumps to the location where
you place the pen (absolute positioning). Press the pen tip on the display screen to make a selection.
Note: You will need to calibrate the pen display tablet to correctly align the screen cursor with
the pen tip. (See Calibrating your pen display on page 20.) If the screen cursor does not jump
to a position close to the pen tip when you place the pen on the display screen, then the pen
tablet driver may not be installed or is not loading. Install the pen tablet driver software if
necessary. Otherwise, refer to Troubleshooting, beginning on page 29.
Clicking: Tap the display screen once with the pen tip, or touch the pen to the display screen with
enough pressure to register a click.
Windows tip: To make navigating with the pen easier, configure Windows to select when the
pen is over an icon and to launch the icon with a single click. To turn on this feature:
Windows XP, XP x64, 2000, or Me. Open a folder, select the T OOLS pull-down menu, and
F OLDER O PTIONS .... From the G ENERAL tab select the option S INGLE - CLICK TO OPEN AN ITEM
( POINT TO SELECT ).
Windows 98SE. Open a folder, select the V IEW pull-down menu, and F OLDER O PTIONS ....
From the G ENERAL tab select the W EB STYLE option.
Double-clicking: Press the upper side switch, or quickly tap the display screen twice in the same place
with the pen tip. Double-clicking is easier when the pen is perpendicular to the tablet screen. To fine-
tune the double-click area, see Adjusting double-click on page 21.
Dragging: Select an object, then slide the pen tip across the display screen to move the object.
Using the side switch: The pen is equipped with a DuoSwitch. This switch has two programmable
functions that can be selected by rocking the switch in either direction. You can use the DuoSwitch
whenever the pen tip is within 5 mm (0.2 inch) of the tablet surface; you do not need to touch the pen tip
to the tablet in order to use the switch. The upper switch is set to D
OUBLE C LICK , and the lower switch is
set to R IGHT C LICK by default.
Drawing with pressure-sensitivity: The pen responds to the nuance and inflection of your hand
movements, enabling you to create natural-looking pen and brush strokes within applications that
support this feature. To draw with pressure, select a pressure-sensitive tool from your application’s tool
palette. As you draw on the screen surface, use various amounts of downward pressure on the tip of
the pen. Press lightly for thin lines or softer color. Press harder for thick lines or dense color.
DTF521_Manual.fm Page 17 Tuesday, February 28, 2006 10:36 AM