Williams Sound Transmitter T36 - Manual (Page 6)

Using the PFM T36 Transmitter
IMPORTANT: If Alkaline (nonrechargeable) batteries are being installed, slide the battery selec-
tion switch in the battery compartment to the “Alkaline” position. See FIG 1 below. If installing
NiMH (or rechargeable) batteries, slide the battery selection switch to the “NiMH” position.
1. Install two (2) AA batteries. Note: rechargeable batteries must be charged before use. See Bat-
tery Information on page 11.
2. Plug the microphone cord into the “Mic Jack” ( ) on top of the transmitter.
3. Optionally, plug in a desired audio source such as a CD or MP3 player using the “Auxiliary Input”
jack (WCA 087 stereo auxiliary input cable included). If the microphone and an auxiliary source are
used together, the audio will be mixed. If only the auxiliary source is desired, the microphone can
be muted. Do not remove the microphone from the “Mic Jack” as the microphone’s cable is also the
transmitting antenna!
4. Turn the unit on: press and hold the “ON/OFF/MUTE” button for three seconds. The “Power On”
indicator ( ) should illuminate green.
5. Select the desired operating frequency. Use the “Channel Selector” knob to select any of the 16
available channels on 72-76 MHz. Refer to the channel selection chart (FIG 9, Page 10). Make
sure the receiver being used is operating on the same frequency as the T36 transmitter.
6. Place the transmitter in a pocket, or clip it onto a belt or waistband (See “BELT CLIP INSTALLA-
TION”, page 10).
AA
AA
–
+
+
–
Comp CH Lock - Gain + - AUX +
2:1
1:1
Mic Jack
Channel
Selector
Power On Indicator
Auxiliary
Input
Power On/Off/Mute
Mic Jack
Channel
Selector
Power On Indicator
Auxiliary
Input
Power On/Off/Mute
Mic Jack
Channel
Selector
Power On Indicator
Auxiliary
Input
Power On/Off/Mute
FIG. 1: Battery Selection Switch
FIG. 2: T36 User Controls
5
H e l p i n g P e o p l e H e a r
4
H e l p i n g P e o p l e H e a r