Waterford Precision Cycles Ceramic Hob - Manual (Page 5)

Voltage: 230V ~ 50Hz
Max Power: 6500W (28.3 Amps)
Plate Ratings:-
Rear Left Hotplate:
O 145mm - 1200W
Rear Right Hotplate: O 180mm - 1800W
Front Left Hotplate:
O 210mm - 2300W
Front Right Hotplate: O 145mm - 1200W
Dimensions: 581mm x 513mm x 48mm
Weight: 8Kg
Complies To: EN 60335 - 1 & EN 60335-2-6
Before selecting a position to install the hob, the
following must be considered:
* Do not install the hob near refrigerating
devices.
* Do not fit the hob over a cooker without a
cooling fan, dishwasher, refrigerator, freezer
or washing machine.
* The worktop the hob is fitted into should be
resistant to temperatures up to 100 o C. This
applies to the veneer, plastic surfaces, glues
and varnishes.
* When installing the electric supply to the hob,
ensure that the cable does not touch any hot
parts of the hob or other units around it.
* Once installed the clearances around the hob
should be as detailed in Fig.1, when fitted on
work top over a carrying cupboard or Fig.2
when fitted on a work top over a ventilated oven.
TECHNICAL INFORMATION
INSTALLATION
POSITIONING & FITTING THE HOB
Fig. 1
Fig. 2
1. Cut out a square opening in the work top, as
shown in Fig.3, with a minimum of 60mm of the
work top behind the opening.
2. Sit the hob into the cut-out on the worktop.
3. Fit the tension brackets loosely and then with
the hob centered tighten all the tension brackets
evenly starting in the centre and moving diago-
nally. (see Fig.4) Fill the gap between the hob
& worktop with a silicone sealer if required.
Fig. 3
4
513
581
Fig. 4
Worktop
Bracket
Seal Ceramic
483
555