VDO Z2 PC - Manual (Page 24)

15
INSTRUCTION MANUAL
IMPORTANT NOTE / Re-open of transmitter search for the receive
channel after interruption
If no signal is received from an already paired transmitter after 15
minutes (for example riding without chest belt for Z2 and Z3, also
PC-LINK models), the receive channel will be closed for this transmitter.
In this case your VDO computer will show dashes for the respective
function in the display. To re-open all receive channels press the ç
and ¥ buttons at the same time: Now your VDO computer will again
receive all previously paired transmitters that are in range.
4. GENERAL SETTINGS
4.1. SETTING THE LANGUAGE
3sec.
ç Setting mode LANGUAGE SELECT
‚ LANGUAGE SELECT
∂ ƒ Select „LANGUAGE ENGLISH“
‚ Automatic return to TRIP DIST
Language selection done.
4.2. SETTING TIME & DATE
3 sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ CLOCK SET
‚ SET HOUR ?CONTINUE?
∂ ƒ Setting hours
‚ SET MINUTES ?CONTINUE?
∂ ƒ Setting minutes
‚ SET YEAR ?CONTINUE?
∂ ƒ Setting the year
‚ SET MONTH ?CONTINUE?
∂ ƒ Setting the month
‚ SET DAY ?CONTINUE?
∂ ƒ Setting the day
‚ CLOCK ?SET OK?
‚ CLOCK SET DONE
Automatic return to CLOCK.
4.3. SETTING THE ALARM, ALARM CLOCK
3 sec.
ç Setting mode LANGUAGE SELECT
∂ ƒ ALARM SET
‚ ALARM ON or ALARM OFF ( (∂ to switch on)
When the alarm clock is switched off setting mode ends automatically by ‚ .
‚ SET HOUR ?CONTINUE?
∂ ƒ Selecting the hours value
‚ „SET MINUTES ?CONTINUE?
∂ ƒ Selecting the minutes value
‚ ALARM ?SET OK?
‚ ALARM SET DONE!
Automatic return to the operation mode for CLOCK. Setting the alarm
clock done. The alarm clock icon is now shown in the display (center
bar left).
5. BICYCLE FUNCTION SETTINGS
5.1. MEASURING AND SETTING WHEEL SIZE/S
In order for your VDO computer to measure correctly you must first
measure the circumference of your wheel. If this value is set incorrectly
then all values calculated on the basis of this value, such as speed, trip,