Xtant 3150X - Manual (Page 9)

MAINTENANCE
Recommended Cleaning Procedures
Cleaning the fan / Circuit Board – Every 90 Days
A. The internal fan in all Xtant amplifiers need periodic cleaning.
If you are in a high dust environment, every 30 days is
recommended. We recommend that your dealer remove
the cover and clean the fan blades with a soft brush.
Loose dust can be removed with a vacuum hose.
Caution: Have your dealer check the fan for obstructions if your
amplifier over heats. When the Thermal Protection
Circuit is engaged, the orange LED will be illuminated
and power may be reduced.
B. Have your dealer check the circuit board for dust. If
present, use a low pressure air source to blow-off the
dust particles. DO NOT use a high-pressure source,
brush or any similar device to clean the circuit board!
Cleaning the Amplifier – Every 30 days
A. Clean the stainless steel cover with a light dust cloth. For
a more thorough cleaning, use window cleaner that is
ammonia free. Apply the cleaner to the cloth (not the
amplifier) and wipe the surface. Take care not to catch the
cloth on the copper mesh.
Caution: Do not allow liquids to touch the circuit board.
B. To polish the stainless steel cover use a commercially
available stainless steel cleaner/polish. It is important to
note that stainless steel has a (directional) grain. Please
read the directions supplied with the polish before
beginning. As a rule of thumb, always polish with the
grain. Apply the cleaner/polish to the cloth (not the
amplifier) and wipe the surface. Take care not to catch the
cloth on the copper mesh.
9