Yamaha PCY100 EN - Manual (Page 7)

7
6 Place one of the felt pads removed in Step 2 on the cymbal holder. (See Figure 5.)
7 Mount the pad unit on the cymbal stand. Lower the pad unit into place with the cymbal holder’s
shaft passing through the central hole of the Cup section. When mounted, the stopper’s pin should
rest inside the pad unit’s smaller hole. (See Figure 5.)
• If you were to play your pad unit without the stopper’s pin positioned fully inside the smaller
hole, it could slip out of the hole as you play.
8 Assemble the felt pad that came with your pad unit. (See Figure 5.)
• The second felt pad removed from the cymbal holder in Step 2 above is not required for
assembly of your pad unit.
9 Tighten the wing nut to secure the pad unit to the cymbal holder. (See Figure 5.)
The function of the PCY series pads varies according to which trigger input jack on the DTX Series
Drum Trigger Module the pad is connected.
Refer to the following website for its function in relation to trigger input jacks.
http://dtxdrums.yamaha.com/support/pad_compatibility/
Pads & Trigger Input Jacks
Cymbal holder
Bolt cover
Wing nut
Felt Pad
Felt pad that came
with pad unit
Stopper
[Figure 5]
Pad unit
Pad unit
Cup
Cup
Stopper’s
pin
Smaller
hole
Pin
pcy100_135_155_en_om.fm Page 7 Thursday, November 11, 2010 5:07 PM