Zanussi DA 6473 - Manual (Page 11)

21
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it under
a close fitting sink unit or a pre-existing top, providing the
dimensions of the recess correspond to those shown in the
picture.
Proceed as follows:
- Remove the machine’s worktop by unscrewing the
two rear retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with
the adjustable feet. When inserting the machine, ensure that
the water inlet and drain hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not
catch on the levelling spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
820
570 - 600
600
IN05
The WRD detergent dispenser
If the programme has a prewash add the required detergent
in the WRD detergent dispenser, located in the centre of the
upper basket.
Check that the WRD is not clogged with detergent residue. If
necessary rinse it under running water after having removed
it from the basket by twisting it anticlockwise and pulling it
upwards.
Fasten it back onto the support by turning it clockwise.
Never use your dishwasher without the WRD
dispenser.
Since WRD also ensures correct distribution of
the water to the upper spray arm, running the
dishwasher without it will impair the washing
results.
MA11
DE13