Yamaha NS-P116 - Manual (Page 13)

English
E-
9
SUBWOOFER SYSTEM YST SW005
INPUT /MONO
AUTO STANDBY
OFF LOW HIGH
OFF
POWER
ON
VOLUME
0 10
220V-240V
110V-120V
VOLTAGE SELECTOR
5
4
6
INPUT /MONO
AUTO
STANDBY
OFF
LOW
HIGH
VOLUME
0 10
OFF
POWER
ON
2
110V-120V VOLTAGE
SELECTOR
220V-240V
3
1
USING THE SUBWOOFER (SW-P130)
Ⅵ Controls and their functions
1
Power indicator
Lights up GREEN when the POWER switch (
2 ) is
pressed in to the ON position and goes off when set to
the OFF position.
* Standby mode
If the POWER switch ( 2 ) is pressed in to the ON
position and the AUTO STANDBY switch ( 4 ) is set
to the HIGH or LOW position, this indicator lights up
RED when no signal is received by the subwoofer.
2
POWER switch
Press this switch to the ON position to turn on the
power of the subwoofer. When the power of the
subwoofer is on, the power indicator (
1 ) on the front
panel lights up GREEN. Press this switch again to set
to the OFF position to turn off the power of the
subwoofer.
3
VOLTAGE SELECTOR switch
(For China, Korean and General models)
If the preset setting of the switch is incorrect, set the
switch to the proper voltage range (220V-240V or
110V-120V) of your area.
Consult your dealer if you are unsure of the correct
setting.
WARNING
Be sure to unplug the subwoofer before setting the
VOLTAGE SELECTOR switch correctly.
4
AUTO STANDBY (HIGH/LOW/OFF) switch
This switch is originally set to the OFF position. By
setting this switch to the HIGH or LOW position, the
subwoofer’s automatic power-switching function
operates as explained on page 10. If you do not need
this function, set to the OFF position.
* Make sure to change the setting of this switch only
when the POWER switch ( 2 ) is in the OFF position.
5
INPUT terminals
Used to input line level signals from the amplifier.
6
VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to
decrease the volume.
Rear panel
Front panel
Port
2-NS-P110-116-U.p65 05.3.11, 4:28 PM 9