Zanussi ZSF 6280 - Manual (Page 11)

11
Setting electronically:
1. Press the ON/OFF button.
3
If the name of a programme stage is displayed
in the display, a dishwashing cycle is active.
First of all you must cancel the dishwashing
cycle:
– Press the Cancel button. CONFIRM CANCEL?
appears in the display.
– Press the Ok/Start button. This cancels the dish-
washing cycle.
2. Go to the WATER HARDNESS setting; see section
“Adapting an option/setting”.
3. Set WATER HARDNESS to the right setting.
If the water softener is set electronically to “1” this
switches off the display of the REFILL SALT mes-
sage.
Water hardness Adjusting the hardness setting
in °d
1)
in mmol/l
2)
Range Manual Electronic
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28 9,0 - 12,5
7,6 - 8,9
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
IV 1
10
3)
9
8
7
6
0*
19 - 22
15 - 18 3,3 - 3,9
2,6 - 3,2
III
5
4*
11 - 14 1,9 - 2,5 II 3
4 - 10 0,7 - 1,8 I/II 2
below 4 below 0.7 I
1
no salt necessary
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for water hardness
3) On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting