Yamaha MSP10 - Manual (Page 4)

5
Front panel/Rear panel
1 Power/Clip indicator
This indicator lights up green when you turn the
POWER switch on the rear panel ON. If the output
level is too high, causing clipping at the amplifier,
the indicator lights up red. In this case, lower the
input level.
2 TRIM switches
These switches enable you to adjust the bass and
treble for the MSP10/10M.
LOW: three positions
The LOW switch adjusts the bass range. With the
“–1” and “–2” settings, the bass range is cut by
1.5 dB when based on a reference value of 50 Hz
with the “0” setting.
HIGH: three positions
The HIGH switch adjusts the treble. With the “+1”
setting, the treble range is boosted by 1.5 dB when
based on a reference value of 10 kHz with the “0”
setting. With “–1” setting, the treble range is cut by
1.5 dB.
3 LOW CUT switch
This switch turns on or off the high-pass filter that
cuts frequency ranges below 80 Hz.
4 SENSITIVITY control
Adjust the volume according to the output
sensitivity of the connected device.
(The factory default setting is “MIN.”)
5 INPUT jack
This is an XLR-type balanced input jack.
6 POWER switch
This switch turns the power to the MSP10/10M on
and off. When you turn this switch on, the power/
clip indicator lights up green.
1
–2 –1
LOW
TRIM
POWER
LOW CUT
0 –1 ON 0
HIGH (80Hz)
+1 OFF
ON OFF
SENSITIVITY INPUT
MIN –6dB
+4dB
6
2 3 5 4