Yamaha NS-225F - Manual (Page 4)

Removing the front cover
The front cover is attached to protect the speaker
unit, but you can remove it if necessary.
The front cover is fixed by magnets. Hold the
speaker with one hand, and pull the front cover
gently with the other to remove it.
Specifications
Type.................2-way bass-reflex speaker system
magnetic shielding type
Drivers............................ 3 cm (1”) dome tweeter
8 cm (3.1”) cone woofer x2
Impedance ...................................................... 6
Ω
Frequency response....................... 60 Hz–50 kHz
Nominal Input power ...................................40 W
Maximum input power...............................120 W
Sensitivity................................... 86 dB/2.83 V/m
Crossover frequency....................................3 kHz
Dimensions (with the stand)
(W
✕ H ✕ D)
........236 (9.3”)
✕ 1050 (41.3”) ✕ 236 (9.3”) mm
Weight ...................................... 7.7 kg (16.98 lbs)
* Specifications are subject to change without
notice due to product improvements.
Notes:
• When removing the cover, be careful that you don’t
touch the drive units, and don’t exert excessive
force with any tools.
• There are magnets on the reverse side of the front
cover. Do not place the front cover close to objects
that might be affected by magnets, such as TVs,
clocks, magnetic cards, diskettes etc. after
removing it.
©2004 All rights reserved.
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.
YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA
YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.R. OF GERMANY
YAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE
YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND
YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN
YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA
Printed in Indonesia WD66630-1
This product mainly uses lead-free solder.
Cet appareil utilise principalement de la soudure sans plomb.
Dieses Produkt verwendet hauptsächlich bleifreies Lot.
Este producto utiliza principalmente soldadura sin plomo.