Yamaha NS-P610 - Manual (Page 12)

E-
8
Notes
● Some amplifiers have line output terminals labeled PRE
OUT. When you connect the subwoofer to the PRE OUT
terminals of the amplifier, make sure that the amplifier
has at least two sets of PRE OUT terminals. If the
amplifier has only one set of PRE OUT terminals, do not
connect the subwoofer to the PRE OUT terminals.
Instead, connect the subwoofer to the speaker output
terminals of the amplifier. (Refer to pages 6 and 7.)
● When connecting to a monaural line output terminal of
the amplifier, connect the L INPUT2 terminal.
● When connecting to line output terminals of the amplifier,
other speakers should not be connected to the OUTPUT
terminals on the rear panel of the subwoofer. If
connected, they will not produce sound.
Subwoofer (General model)
Amplifier
Pin plug cord
(included)
To AC outlet
Various ways of connecting the subwoofer
● To connect with a YAMAHA DSP amplifier (or AV
receiver), connect the SUBWOOFER (or LOW PASS etc.)
terminal on the rear of the DSP amplifier (or AV receiver)
to the L INPUT2 terminal of the subwoofer.
Ⅵ
Connecting the subwoofer to line output (pin jack) terminals of
the amplifier (The basic way)
Connect the main speakers to the speaker output terminals of the amplifier.
● To connect the subwoofer to the SPLIT SUBWOOFER
terminals on the rear of the DSP amplifier, connect them
to both the left L and right R INPUT2 terminals of the
subwoofer.
Pin plug cords
(not included)
OUTPUT INPUT2 TO SPEAKERS
INPUT1 FROM AMPLIFIER
LOW HIGH
OFF
AUTO STANDBY
240V
VOLTAGE SELECTOR
POWER
ON
OFF
OUTPUT INPUT2
TO SPEAKERS
INPUT1
FROM AMPLIFIER
LOW HIGH
OFF
AUTO
STANDBY
SPLIT SUBWOOFER
SUBWOOFER
( LOW PASS )