Zoom 1204 - Manual (Page 33)

■ 32 ■
Was editing carried out in memory mode? The effect settings called up in memory mode have
no relationship to the position of the controls on the
front panel. If a setting was not edited, the original
(stored) setting, not the current position of the
control, is effective. Therefore the stored settings
will not reflect the control positions.
Was a setting made with MIDI control change
messages? Settings made with MIDI control change messages
are only temporary and do not result in actual setting
changes. If the store function is carried out, the
stored contents will be the same as the original
settings in memory.
Memory settings cannot be
called up or memory
numbers cannot be
changed. Is the unit in manual mode? Use the MODE key to switch to memory mode.
Is the unit in recall mode? Press the CANCEL key to switch to memory mode.
Are effects switched off? Press EFFECT key to turn effects on.
Is the store function active? Press the STORE key or CANCEL key to terminate
the store function.
Is the MIDI channel setting function active? Press the MIDI key or CANCEL key to terminate
the function.
Stored settings are different
from established settings.
Symptom Check Remedy
Control via MIDI cannot be
carried out. Is the unit in manual mode? Use the MODE key to switch to memory mode.
Is the unit in recall mode? Press the CANCEL key to switch to memory mode.
Does the MIDI channel setting match the send
channel? Set up the 1204 to receive the required channels,
using the MIDI channel setting function.
Are messages other than control change messages
and program change messages being sent? Other MIDI messages such as "Note On," "System
Exclusive Data," "Start/Stop," "NRPN," etc. are
ignored.
Are program change numbers and control change
numbers correct? For information about numbers, refer to the MIDI
implementation.
Is the store function active? Press the STORE key or CANCEL key to terminate
the store function.
Is the MIDI channel setting function active? Press the MIDI key or CANCEL key to terminate
Is the MIDI OUT jack of the other device
connected correctly to the MID IN jack of the 1204? Make connections as described in "Connections."
the function.
Symptom Check Remedy